tooth point

In down milling , maximum chip thickness cecum close to the point tooth contacts the work.

顺铣时, 最大切屑厚度产生于靠近刀具与工件接触点处.

网络文摘精选

If the sliding piece was pulled off the steering shaft, the notch must point towards the tooth gap during assembly.

如果滑动件被从转向轴上拔下，则在装配期间切口必须指向齿隙。

provided by jukuu

Study on solution of engaging tooth contact point trace line by network method

网络法求解相啮合齿面接触迹线的研究

互联网摘选

it pointed out that the design of gear cutter should greatly increase the tooth point arc so as to reduce the stress concentration to increase the force of tooth root.

指出通过计算作出图形，可分析出滚刀齿顶圆弧的设计是否合理。

互联网摘选

The QX straight conjugate internal gear pump is a new type of hydraulically driving element. The calculation of tooth profile, the limiting point of meshing, the designing process of slotting cutter were introduced.

介绍了一种新型液压动力元件&QX型直线共轭内啮合齿轮泵的齿廓曲线计算、专用插齿刀具设计方法，分析了齿廓啮合极限点。

互联网摘选

These formulae are suitable for any contacting point of tooth surface meshing.

这些公式适用于齿面啮合的任何接触点.

互联网摘选

Two formulas of compound shaper cutter are ob-tained. They are used to calculate the pitch pressure angle of chamfer involute and radius of circle on which chamfer involute starting point lies, and to check the tooth root slot width.

得到了复合插齿刀倒角渐开线分度圆压力角，倒角渐开线起始点所在圆半径的设计公式及插齿刀齿根槽宽的验算公式；

互联网摘选

Utilizing the theory of differential geometry, elastic deformation and wear abrasion and running-up of the tooth surfaces in circular arc gears, an elastohydrodynamic lubrication ( EHL) model of point contact with two-dimensional surface velocities was developed.

从圆弧齿轮齿面微分几何分析、弹性接触变形和跑合磨损分析，建立了具有二维表面速度的点接触弹流基本模型。

互联网摘选

A New Method for Solving Instant Meshing Point of Real Tooth Surface& Zero Gape Method

真实齿面瞬时啮合点求解算法的研究&零间隙法

互联网摘选

Pitch Point is the intersection of the spline tooth profile with the pitch circle.

节点是键齿的齿廓与节圆的交点.

互联网摘选

Pitch Point is the intersection of the spline tooth profile with the pitch circle.

节点是键齿的齿廓与节圆的交点.

互联网摘选